IPB-5000B
1. Special Precautions
1-4
(2) Precautions for Handling
When transporting or moving the Power Supply, do not lay it down. Also, handle
the Power Supply with care so as not to make an impact such as drop on it.
Install the Power Supply on a firm and level surface. If it is used inclined or on its
side, it may have a malfunction.
Also, provide 10
cm clearance to the intake and exhaust for improving the effect of
heat release (Refer to 5. (1) Installation).
Do not install this Power Supply in the following places:
▪ Where there is considerably damp (humidity is higher than 90%).
▪ Where the ambient temperature is above 40°C or below 5°C.
▪ Where there is nearby high noise source.
▪ Where the Power Supply may be exposed to chemicals.
▪ Where moisture may be condensed on the surface of the Power Supply.
▪ Where there is considerable dirt.
▪ Where the Power Supply may be subjected to vibration or impact.
▪ Where the altitude is above 1000 meters.
If the outside of the Power Supply is stained, wipe it with a dry cloth or a
moistened cloth. If it is badly stained, use diluted neutral detergent or alcohol to
clean it. Do not use paint thinner, benzene, etc., which can discolor or deform the
parts.
Do not put screws, coins, etc., in the Power Supply, as they may cause a
malfunction.
Operate the Power Supply according to the method described in this operation
manual.
Operate the switches and buttons carefully by hand. If they are operated roughly
or with the tip of a screwdriver, a pen, etc. they may be broken.
Operate the switches and buttons one at a time.
If two or more of them are operated at a time, the Power Supply may have trouble
or may be broken.
The Power Supply is not equipped with auxiliary power such as an outlet for
lighting.
The cable to supply power, the welding head, the welding transformer, and cables
for connecting among the welding head, the welding transformer and the Power
Supply are separately needed to use the Power Supply.
The I/O signal line to start the Power Supply is not attached. Prepare the crimp-on
terminal and line for wiring to the terminal block.
(3) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time
of disposal, separate it from general industrial waste or domestic waste and carry
out the disposal in accordance with applicable laws and regulations.
To Next Page
Loading...
