noise in FM mode.
1. Check/move the antenna. Also try to
adjust the length of antenna.
Alarm does not work.
1. Switch on the alarm.
solutions of ‘No sound’.
but there is no network connection. Change
the source of alarm or reconfigure the
connection.
Remote control does not
work well.
1. Check if any obstacle between the
remote control and the receiver.
change the batteries.
18
1. Turn off mute function.
2. Increase the volume.
3. (Aux-in mode) Check if the audio cable is
connected properly and the volume of the
source device is turned up.
No sound.
2. Move the radio to other location.
No signal in DAB or white
2. Low battery of the remote control,
3. The source of alarm was set to be station
2. Due to low volume setting, refer to the
To Next Page
Loading...
