5
Caution
To avoid personal injury and property
damage, confirm shelf is secure before
placing items on shelf.
Water Filtration System
The Amana
®
Clean ‘n Clear
™
water filtration system
provides water treatment with a revolutionary 2-stage
design. Refer to Clean ‘n Clear
™
water filtration
system installation and operating instructions.
Spillsaver
™
Shelves
Spillsaver
™
shelves are constructed of polypropylene
molded around the glass and metal rail. Therefore,
Spillsaver
™
shelves are completely encapsulated and
liquids cannot seep under the glass. This localizes spills
and provides easier cleaning. Spillsaver
™
shelves also
adjust to meet individual storage needs.
Caution
To avoid personal injury or property
damage, handle tempered glass shelves
carefully. Shelves may break suddenly if
nicked, scratched, or exposed to sudden
temperature change.
• Remove shelves by lifting front, releasing hooks
from metal track then pulling out.
• Replace shelves by inserting hooks into metal track
and lowering front.
Door Open Alarm
Door open alarm sounds and indicator light blinks if
either door is open for more than 3 minutes.
• Deactivate door open alarm by pressing Alarm Off
pad or by closing either door.
• Activate door open alarm by pressing Display On
pad then holding Alarm Off pad for 3 to 5 seconds.
Three short beeps indicate instructions were
accepted.
High Temperature Alarm
High temperature alarm sounds and indicator light glows
if refrigerator or freezer temperature is high for 2 hours.
A blinking light signals affected compartment. Alarm
ends when proper temperature is reached.
• Deactivate high temperature alarm by pressing
Alarm Off pad.
Thermistor Alarm
Thermistor electronically senses refrigerator and freezer
temperatures. Thermistor alarm sounds and indicator
lights scroll if refrigerator or freezer thermistor is not
operating properly.
• Deactivate display by pressing Alarm Off pad.
If thermistor alarm sounds, contact an authorized
Amana
®
technician immediately. If Alarm Off pad is
pressed, thermistor control retests to confirm situation
has been corrected. Alarm sounds again if thermistor is
still not operating properly.
Display Lights
• Deactivate temperature display lights by pressing
Display On pad then pressing Display Off pad.
• Activate temperature display lights by pressing
Display On pad.
Setting Controls
Set controls precisely with a household thermometer
that includes temperatures between -5° to 50°F
(-21° to 10°C).
Put thermometer snugly between frozen packages in
freezer section. Wait 5-8 hours. If freezer temperature is
not 0° to 2°F (-17° to -16°C), adjust control, 1 number at
a time. Check again after 5-8 hours.
Put thermometer in a glass of water in middle of
refrigerator section. Wait 5-8 hours. If refrigerator
temperature is not 38° to 40°F (3° to 4°C), adjust
control, 1 number at a time. Check again after 5-8
hours.
Refrigerator Features
To Next Page
