Amana B136CAL1 - Adhesives; Door Gaskets; Glass Shelves; Door Stop Adjustment

9
Adhesives
1. Remove glue residue by rubbing toothpaste into
adhesive with fingers until adhesive loosens.
2. Rinse surface with warm water. Dry surface with a
soft, clean cloth.
Door Gaskets
1. Clean door gaskets every 3 months according to
“General” instructions.
2. Apply a light film of petroleum jelly to keep gaskets
pliable.
Glass Shelves
Caution
To avoid personal injury or property damage,
handle tempered glass shelves carefully.
Shelves may break suddenly if nicked,
scratched, or exposed to sudden temperature
change.
Remove shelf by lifting front, releasing hooks from
metal track then pulling out. Place shelf on a towel.
Allow shelf to adjust to room temperature before
cleaning.
Clean crevices by completing the following steps:
1. Dilute mild detergent and brush solution into
crevices using a plastic bristle brush. Let set for 5
minutes.
2. Spray warm water into crevices using faucet spray
attachment.
3. Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering front.
Door stop arm
Door Stop Adjustment
1. Remove center grille blade from top air grille.
2. Remove top air grille by removing (4) ¼” screws
with a magnetic screw driver. Pull assembly
forward.
3. Open refrigerator door so door stop arm and
shoulder screw are accesible. Shoulder screws
should be in 110° door opening position.
4. Remove shoulder screw and place shoulder screw
in the 90° or 120° door opening postion.
5. Replace air grille assembly.
Shoulder screw
120° door
opening
position
90° door
opening
position
110° door
opening
position
Freezer lights
Light Bulbs
WARNING
To avoid electrical shock which can cause
severe personal injury or death, turn power
disconnect switch to off position before
replacing light bulb. After replacing light bulb,
return power disconnect switch in on position.
Caution
To avoid personal injury or property
damage, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
• Remove cover by removing screws. Cover drops
down. Replace with maximum 40 watt light bulbs.
• Replace cover by holding cover against ceiling.
Insert and tighten screws.
Refrigerator
lights
Drain Pan
Prevent condensation from overflowing by checking
drain pan periodically. To remove drain pan, remove 4
screws in toe grille. Pull drain pan forward. Dump any
condensation and replace drain pan.
cover
cover