Amana CRC18T2OG User Manual

RS2240002 Rev. 0 A–22
Part Description
Air Intake Filter Filter is located below oven door. Clean air intake filter weekly for proper
airflow. Wash filter in hot water and mild detergent. Do not use oven
without filter in place. Remove filter to clean.
Important
To avoid overheating and oven damage, clean air filter regularly.
1. Grasp filter tab and pull forward. Filter will release from retaining clips.
2. To reinstall, place bottom of filter in clips and push top of filter into
position.
Splatter Shields Splatter shield keeps top of microwave oven cavity and antenna from
becoming soiled. Clean soil from shield with damp cloth or clean with mild
detergent and water. Remove splatter shield for easy cleaning.
Removing Splatter Shield
1. Unplug oven before removing splatter shield to stop antenna from
rotating.
2. Place fingers behind shield, pull forward, and down.
• When removing and replacing splatter shield, be careful not to bend
antenna.
• If a gap for fingers behind splatter shield does not exist, push up on
splatter shield front. Splatter shield may not be installed fully and
cannot be removed until splatter shield front is properly installed.
3. Reinstall splatter shield by placing front tabs over lip at top of oven
cavity front. Lift back of shield until shield snaps into place.
4. Reconnect power to oven.
Changing Oven Light Bulb
Important
To avoid burns and cuts, wear gloves to protect hands should bulb
break. If hot, allow bulb to cool.
Tools and Bulb
• Protective gloves
• Standard screwdriver or ¼-inch socket
• Light bulb rated 120 volt, 25 watt
1. Unplug oven.
2. Remove screw from side of oven.
3. Remove bulb by turning counterclockwise, being careful not to burn
fingers or break bulb.
• Replace with bulb rated 120 volt, 25 watt.
4. Reconnect power to oven.
Shield
up side down
Shield in
correctly

Amana CRC18T2OG Specifications

General

Brand	Amana
Model	CRC18T2OG
Category	Microwave Oven
Language	English