16
Disassembly
1. Disconnect power to oven and remove outer case.
2. Disconnect and label wires from controller/timer.
3. Open oven door.
4. Remove screw securing top of control panel to cavity. Lift control panel up and out to release tabs.
Disconnecting Wire Terminals
All wire terminals are locking-type terminals.
Proceed as follows to disconnect wire terminals:
Insulated terminals:
Grasp insulator pod and pull back. DO NOT PULL ON WIRE.
1 Grasp
Wire
Insulator
Pod
2
Pull
Non-insulated terminals:
Use a small blade screwdriver to depress locking-tab and pull on terminal. DO NOT PULL ON WIRE.
1
Release
locking-tab
Wire
2Pull
Control Panel Removal
2011 RFS Training Manual.indd 16 10/3/2011 8:36:43 AM
To Next Page
Loading...
