RS5290000 Rev. 0 90 April 1998
Kit Instructions
Procedure
Caution
To avoid personal injury or property damage, two
people should remove and rehang each door.
Caution
To avoid personal injury, protect hands and arms. Trim
pieces may have sharp edges.
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
2. Dispenser Models
Remove crushed/cubed ice switch cover on
dispenser by pulling forward. Remove screws from
bottom of dispenser cover. Release bottom clips on
dispenser cover by placing taped edge of putty knife
underneath cover and pulling out. Release top clips
by holding bottom of dispenser cover out and sliding
up.
3. Remove door handle inserts by placing screwdriver
at top of door handles in area between handle and
insert and pulling out.
4. Pull inserts out along length of handles.
5. Install new handle inserts by reversing steps 3-4.
Important
One door handle insert (Item #7 or #8) will be discarded
on DS23 kits.
6. Remove thin section on top handle end caps to
allow room for panels. Discard section. Replace
top handle end caps by placing end caps on
handles. Insert and tighten screws.
Thin Section
To Next Page
Loading...
