April 1998 91 RS5290000 Rev. 0
Kit Instructions
Trace around top hinges with a pencil. This helps
alignment when reassembling. On electronic and
dispenser models, unplug top hinge wire
connectors. Remove top hinge screws.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, green ground wire must
remain attached to hinge.
13. Remove tape from refrigerator door. Grasp
refrigerator door securely and lift up while opening.
This will free door from bottom hinge pin. Top hinge
may come off door. On electronic control models,
wiring harness must slide through slot in bottom
hinge.
Caution
To avoid property damage, drain water from water tube
into small bucket.
14. Dispenser Models
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Gently pull water tube away
from union nut and through tube clamp.
7. Dispenser Models
Replace dispenser cover by snapping in place.
Insert and tighten screws. Replace switch by
snapping in place.
8. Remove toe grille by pulling forward.
9. Electronic Control Models
Unplug wiring harness from voltage box in center of
refrigerator cabinet behind toe grille.
10. Electronic Control Models
Release wiring harness from plastic retainer clips on
bottom of refrigerator cabinet. Open door
approximately 120° and locate screw holding plastic
door closure to top of bottom hinge. Remove screw
and close door.
Caution
To avoid personal injury or property damage,
temporarily tape doors shut.
11. Tape doors shut using masking tape.
12. Remove top hinge covers by removing screws.
Plastic Door Closure
Screw
To Next Page
Loading...
