- 4 -
Setting Up the Light
Installing strip light
1. Choose a dry, clean and smooth surface to install the strip light.
2. Clean the mounting surface with the included cleaning kit.
3. When the ambient temperature is lower than 10℃/50℉, please use a hair dryer to heat it before installation
to achieve the best adhesive effect.
4. After confirming the installation position, remove the dustproof paper tape from the double-sided tape on the
back of the strip light, and mount the strip light to your chosen surface.
5. After the strip light is installed, use the included double-sided tape to reinforce any corners or areas where
the adhesive is not strong.
6. After arranging the control box and wires to the desired position, fix them with double-sided tape.
*Do not install strip light on surfaces such as fabric, dusty walls, rough plastic, and frosted glass.
Strip light
Double-sided tape
✘
✘
✘
✘
To Next Page
Loading...
