16
Operation Method
Operation Method
Warning
1. Be careful not to press on the head;
2. When fitting the water tank, ensure the head inserted into the hole first;
3. If you found the washer reversed or loosed when removing the tank,
you must take off the fixed holder by contrarotating it first, then put
the washer to the correct position, and install the fixed holder at last.
Level of appliance
• For sufficient leveling and air circulating in the lower rear section of the appliance, the bottom feet may need to be adjusted.
You can adjust them by your fingers or a suitable spanner.
• To allow the doors to self-close, tilt back the top backwards for about 10mm or 0.5° by turning the adjustable feet.
• Whenever you want to move the appliance, remember to turn the feet back up so that the appliance can roll freely. Reinstall the
appliance when relocating.
Water Dispenser
The water dispenser, located in the fridge door, is for storing drinking water. With this appliance you can obtain chilled
water easily without opening the refrigerator. You should be informed of following tips.
• Before using this appliance for the first time, you should use it as follows.
1. Hold the two sides of the water tank tightly, then pull up the water tank by shaking up and down.
2. Unscrew the head, then clean it and the inside of water tank.
• Before assembling, please drain the water inside the tank, and check whether the washer is reversed or not.
1. Insert the head into the hole.
2. Fit the tank along the guides on the door.
3. Press down on the two side of the tank.
4. When you hear a click sound, that means the installation is completed.
fixed holder
washer
Slot
Guide
Head
wrong position
correct position
To Next Page
Loading...
Need help?
General