Specifications
Specifications
17
• Before you fill the drinking water into the water tank, ensure that the water tank is steady and in a correct position.
1. Insert the head into the hole.
2. Fit the tank along the guides on the door.
3. Press down on the two side of the tank.
4. When you hear a click sound, that means the installation is completed.
• Dispensing water
1. Make sure the cover of the water tank is fitted on.
2. Close the fridge door and check the dispenser.
• Receiving Water
You should use the correct cups to receive water underneath
the water dispenser.
Before you dispense the water, make sure the lock device is on “UNLOCK” situation.
Caution! Fill with water up to 3L (which is suggested), and not above the level. Otherwise, it may overflow when the lid is close.
We recommend that you fill the water by the following ways.
1. Remove the small lid and fill water from the inlet of the large lid.
2. Remove the cover of the tank, and then fill water inside directly.
Warning
Don't touch other parts of the appliance when filling water, it may cause the water leakage.
Warning
The lock is defined as “child lock”. Don't push the dispenser lever forward strongly, when the dispenser is on “LOCK” situation,
it may damage the mechanism.
• Cleaning
1. Put the water tank out of the door carefully, and then wash the tank, id, and head lightly in water.
2. After you have successfully cleaned the appliance, you should dry it by natural drying or using the dryer.
3. If you have used the water dispenser for many times, the water in thereceiving tank may drop on the floor,
which may make your floor wet, and you should clean the tank with dry towel regularly before overflow.
Warning
Don't push the dispenser lever forward without cup, it may cause the water leak from the dispenser.
Small Lid
Head
Large Lid
Dispenser
Lever
Suggested
Position
Lock
To Next Page
Loading...
Need help?
General