Page 32 of 38
Domestic Hot Water
Start Up Procedure
Continued
NOTE: On this screen, you will also see
Enable Scheduler: NO
If this function is selected to: YES
You can then scroll down using the DOWN arrow button
and select when you would like your hydronic heating
or cooling times to run – Enter your desired start stop
times in the 7 Day Event 1: and Event 2 Set Up Pages
This function can be set up for commercial hot water
heat pump models
NOTE: Domestic Hot Water Boost
✓ To test run Domestic Hot Water Operation either install a
domestic hot water boost button or bridge out
terminals GND + 5 on the external digital input control
box. Hold in for 3 seconds to initiate Domestic Hot Water
Cycle
To Next Page