Page 33 of 38
Commercial Hot Water
Heat Pump Unit
Quick Start Procedure
✓ Press the Target Temp button and the setting screen will
now be displayed. Press ENTER button and the curser
will now be flashing on Mode: OFF. Press the UP or
DOWN arrows to select Heat ONLY or OFF. Press the
ENETR button when desired mode is flashing
✓ Set Heating Water Target Temperature using UP or
DOWN arrows then press ENTER
✓ Press RETURN button to return to MAIN SCREEN.
Heat pump unit will now start to run on selected mode
✓ Keep an eye on system supply and return water
temperatures. Check system pumping flow rates and
proceed to bleed air from all air bleed points on Hot
Water System
✓ Run system through heating cycle to check operation
✓ Full system operation real time date can be viewed by
pressing the DOWN arrow button from the MAIN
SCREEN
✓ Keep pressing the DOWN arrow to view all heat pump
operation screens
To Next Page