Ambu aView - Appendix 2. Warranty and Replacement Program

EN
Recommended Separation Distances Between Portable and Mobile RF Communication
Equipment and system.
The system is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The user of the system can help prevent electromagnetic
interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters and the system as recommended below,
according to the maximum output power of the communication equipment.
Rated maximum
output power (W)
of transmitter
Separation distance (m) according to frequency of transmitter
150kHz to 80MHz
D = 1.17√P
80MHz to 800MHz
D = 1.17√P
800MHz to 2.7GHz
D = 2.33√P
0.01 0.12 m 0.12 m 0.23 m
0.1 0.37 m 0.37 m 0.74 m
1 1.17 m 1.17 m 2.33 m
10 3.70 m 3.70 m 7.37 m
100 11.7 m 11.7 m 23.3 m
For transmitters rated at a maximum output power not listed above, the recommended
separation distance (D) in meters (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter
in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
Appendix 2. Warranty and Replacement Program
The warranty period for the aView is one year from delivery to the customer. Ambu agrees
to replace an aView free of charge if proof can be provided of faulty materials or faulty
workmanship. In doing so Ambu cannot accept the cost of transportation or risk of shipment.
Repair of an aView due to faulty materials or faulty workmanship may be offered in situations
where this option is available. Ambu holds the right to make the choice between repair or
replacement in every situation.
Ambu holds the right to ask the technical department at the customer site, or a similar
department, to carry out repair of an aView under proper guidance by Ambu.
A defective aView must be handled exclusively by persons authorised by Ambu A/S.
To prevent infection, it is strictly forbidden to ship contaminated medical devices.
The medical device (aView or Ambu visualization device) must be decontaminated on site
before shipment to Ambu. The cleaning and disinfection procedures explained in section 5
shall be followed. Ambu reserve the right to return contaminated medical devices to the sender.
17