A
A
1
2
3
4
11
3. Automatic steaming with
Softiera insert and EasyQuick
➔Prepare the food.
➔Select suitable pot and place Softiera insert inside. Fill a cup of
water (approx. 120-150 ml) in the pot, ensuring that the water level
is not higher than the perforated base surface. Place the prepared
food inside.
➔Fit sealing ring that corresponds to the diameter of the pot in the
EasyQuick and place it on the pot.
➔
1
Place pot on Navigenio and set it at Automatic “A”. Switch on
Audiotherm with right or left button, enter desired cooking time
with right button, e.g. 10 minutes.
➔
2
Fit Audiotherm on Visiotherm E, turn until steam and radio
symbol appears.
3
Navigenio now has radio contact and flashes blue. Now
everything runs fully automatically: Navigenio and Audiotherm
control the heating and reduction of energy completely by
themselves and monitor the cooking time as well.
4
The ideal temperature is maintained automatically during the entire
cooking time.
➔If you want to add another ingredient after some time, remove the
Audiotherm from the Visiotherm E and lift the EasyQuick. Add the
ingredient and fit the EasyQuick again. Fit Audiotherm on Visio-
therm E again, turn until the steam and radio symbol appears and
cook completely.
When the set time is over, you will be called to eat with a single
beep. If you are not at the place immediately, no problem: Food is
kept warm at 60 °C for one hour.
➔At the end, switch o Navigenio’s power plug.
AMCI_EasyQuick_II_GAL_21042016.indd 11 21.04.16 12:28
To Next Page
Loading...
Need help?
General
