Amcor MF 12000E - Unit Operation Modes; Power On;Off and Modes; Timer and Sleep Settings; Auto and Compressor Functions

OPERATION
Three minutes later after power on / restart, compressor starts to run.
Press”MODE” to select dehumidifying mode.dehumidifyin mode indicator turns on
Under dehumidifyin mode,sleeping function can not be setup ,and fan speed is low
If the unit will be used mainly as a dehumidifier,continuous drainage(see separate chapter) is then
necessary and more efficiency
When machine turns on, , the louvers will swing continuously left and right; by pressing the
button
again the movement will stop and the louver remain in that position.
Dehumidifying Mode
Auto Mode
Compressor Protection
under auto swing
On/Off
Press “POWER” to switch the unit On or Off
Cooling Mode
After machine turns on, default value is cooling mode with 22ºC and low fan speed.
Press “MODE” to select cooling mode, cooling mode indictor turns on .
Press “UP” or “DOWN” to adjust temperature (from 16ºC to 31ºC).
Press “SPEED” to select fan speed (low, high)
Fan Mode
Press “MODE” to select fan mode, fan mode indicator turns on .
Press “SPEED” to select fan speed (low, high)
Temperature and sleeping function cannot be setup.
Timer Mode
Under standby mode, press “TIMER” to setup the power-on time,
press “UP” and “DOWN” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.
Under power-on mode, press “TIMER” to setup power-off timer.
Press “UP” and “DOWN” to adjust the timer (from 1 to 24 hours). Timer indicator turns on.
Sleeping Mode
Press key “SLEEP” enter into sleeping mode, default value of fan speed is low.
When sleeping mode turns on , under cooling mode, the one hour later, setting temperature will go up
1ºC, the second one hour later, setting temperature will go up another 1ºC, and then keep the same;
Sleeping mode is invalid under dehumidifying and fan mode.
Under water full, machine standby and mode conversion, sleeping mode will be cancelled .