Remote control
The air conditioner responds to all signals that are sent by the remote
control.
Two AAA-batteries are required to use the remote control.
Note: the air flow direction can not be adjusted with the remote control.
Important:
t The compressor will start approximately 3 minutes after the unit is turned on
(this will help prolong the life of the compressor). After switching the unit off,
please wait at least 3 minutes before turning the unit back on.
t The cooling will switch off when the room temperature is lower than the set one.
Ventilation will however continue to work at the set level. When the ambient
temperature rises above the chosen value, the cooling will resume.
There will be a beep sound from the unit after receiving the signal.The operation of
the unit by remote control is identical to the operation by the control panel
Remote Control
1. Power 2. Timer 3. Down 4. Mode
5 . Up 6. Fan 7. Sleeping 8. Swing
Screen
1. Cooling mode indicator
2. Dehumidify ing mode indicator
3. Fan mode indicator
4. Swing mode indicator
5. L ow fan speed
6. Temperatur e display
7. High fan speed
8. Timer mode indicator
9. Sleeping mode indicator
10. Water full indicator
t
t
t
t
To Next Page
Loading...
