7. Web Access Setup for PC (Local & Remote)
Local Access Procedure
For purposes of this guide, we will outline the most common method for setting up local web
access. For this method, your DVR should be connected to your router, and the computer you
are using to access the DVR’s web interface should be connected to the same router, either
wirelessly or via a wired connection.
1. Login to your DVR, open the main menu then go to Network -> General.
2. Ensure that the option for DNS is set to Static DNS.
3. Write down the IP address that is located in the IP Address field.
4. Click the Advanced tab at the top and change the HTTP port to any 4 digit number above
1024.
5. Click the Apply button at the bottom right hand of the page.
6. Write down the HTTP port number you inputted in the HTTP port field.
7. Open up a web browser and type in the IP address you wrote down, and then add a
colon mark, and add the port number to the end. The IP should look something like the
following: http://192.168.2.135:1111
8. Install the plugins onto your browser.
9. Once installed, enter in your login credentials and click Log In.
10. Save this page as a bookmark so you can quickly access the interface while on the same
network.
To view a video on how to setup the 960H DVR for local web access, go to
http://amcrest.com/videos and view the video titled “How to Gain Remote Access to Your 960H
DVR with Universal Plug and Play”.
For detailed operation information about web access, please refer to the User Manual included in
the packaged CD, or the paper copy of the User Manual included with the system.
To Next Page
Loading...
