17
3
1
2
7.4 To Begin Pumping
STEP 1: CONNECT THE POWER ADAPTER
Insert the power adapter into LEFT side of
pump base.
STEP 2: INSERT TUBING
Insert the tubing into the adapter into RIGHT
side of pump base, then turn slightly to the
right while pushing in firmly.
A. For DOUBLE PUMPING: Both
tubes should be attached to the
tubing adapter.
B. For SINGLE PUMPING:
Remove one tube from the tubing
adapter and close one side.
STEP 3: PLACE THE FLANGE ON BREAST
Center flange on breast to create seal.
Check breast flange fit, if pumping causes
discomfort a larger or smaller breast flange size
may be needed. See section on how to properly
fit your flange.
STEP 4: POWER ON THE PUMP
Press the Power button to turn on the device.
It will begin in Stimulation Mode.
4
To Next Page
Loading...
