20
8. CLEANING THE HYGIENIKIT
After Every Use: Cleaning The HygieniKit
1. POP OFF the adapter cap from the flange.
2. SET ASIDE adapter cap, tubing and tubing
adapter— you do not need to take these apart
from each other. These 3 parts DO NOT need to
be washed before first use or after each use— milk
does not come into direct contact with these parts.
Take apart the remaining parts, the diaphragm(s), the
flanges, valve and milk storage bottles, including locking
ring and locking disc, since these are the parts that can
touch the breast milk once you begin pumping.
ALWAYS wash hands well with soap and water.
CLEANING: Cleaning with warm, soapy water
After every use, unless otherwise directed by your healthcare provider, prepare
the product for use as follows:
Set aside tubing, adapter cap and tubing adapter. These
parts need to be washed.
!
2 3 4
Hand WASH all
parts - except for
tubing, adapter
cap and tubing
adapter - with
warm, soapy
water. Do not
insert anything
into valve while
cleaning.
RINSE well with
warm, clean
water.
Air DRY each
part on a clean
surface.
RINSE any milk
from pump parts
with cool water.
1
*Ameda does not recommend
inserting anything into the
valves and backflow protectors
for cleaning but if you want to
use a brush or sanitizing steam
bags, then it is very important
to check for cracks, chips. tears
or deformation before and
after use.
Pump parts may vary.
DO NOT wash
adapter cap, tubing
and tubing adapter.
To Next Page
Loading...
