Ameda Platinum - Set Up and Assembly; HygieniKit Milk Collection System; Single and Dual Pumping Setup; Controls and Displays Operation

6 ENGLISH
Tubing
Silicone Diaphragm
Adapter Cap
Milk Bottle
Valve
Breast Flange
Tubing Adapter
The Ameda HygieniKit Milk Collection System can be used
to single or dual pump.
To dual pump:
Both tubes should be
attached to tubing
adapter.
To single pump:
Remove one tube and
close tubing adapter.
Set Up and Assembly
Ameda HygieniKit Milk Collection System
Before Every Use
Always wash hands well with soap and water before
handling the Ameda Platinum Breast Pump and
Ameda HygieniKit Milk Collection System.
IMPORTANT NOTE: ONLY USE THE AMEDA HYGIENIKIT
MILK COLLECTION SYSTEM ON AMEDA ELECTRIC BREAST
PUMPS.
Prior to starting pump, assemble and connect the Ameda
HygieniKit Milk Collection System, per included instructions.
If the Ameda HygieniKit Milk Collection System is sterile, use
as is. If not sterile, see the Ameda HygieniKit Milk Collection
System cleaning instructions.
Ameda Platinum Breast Pump
Pump
•AttachAmedasupplied
grounded power cord to AC
power inlet on rear of pump.
•Connectgroundedplugto
wall outlet.
Controls and Displays
Before starting pump, please note how the controls work.
•Pressandreleasecontrolstoincrease/decreasesettings
by increments of 1.
•Pressandholdcontrolstoincrease/decreasesettingsby
increments of 10.
Operating the Pump
•Whenpumpispluggedin,a
light will appear next to the
Power button.
•PressthePower
button. The displays light up.
PumpisnowON.
•Pumpstartsatlowest
suctionsetting(1%or
approximately 30mmHg/
4.0kPa)andmaximum
speed(80cpm).
Setting Suction
•Pump starts at lowest suction
setting(1%orapproximately
30mmHg/4.0kPa).
•Centernipple(s)inbreast
ange(s)andllbreast
ange(s)withthebreast(s)
to create an air seal.
•Presstoincrease
suction until reaching
maximum comfort level.
• Ifdiscomfortisfeltinnipple(s)
orbreast(s),decreasesuc-
tion. If discomfort is felt at
all suction settings, turn
pump off, insert a finger
betweenbreast(s)andbreast
ange(s)tobreaksuction,
remove breastange(s)from
breast(s). Discontinue
pumping and contact a
healthcare provider.
Setting Speed
•Pumpstartsatfastestspeed
(80cpm).
•Whenmilkows(let-down),
press to a slower
speed to help drain the
breast faster.
•Whenmilkowslows,
press to 60-80 cpm to
help start another let-down.
•Repeatasmilkowchanges
to pump more milk.
NOTE: If “Check Kit” appears in suction window, see
Troubleshooting section, on page 7.
suction
speed
suctio
n
speed
suction
time
r
e
ed
•Inserttubingadapterinto
tubing adapter port.
1
2
3
4
5