INTRODUCTION
Congratulations on the purchase of your new AMERGRAPH AdVantage
®
SCREEN
EXPOSURE SYSTEM, one of the most technologically advanced exposure systems
available. To make installation of your new machine easier and safer, we recommend the
following:
It is advisable to have the assistance of several individuals while
unpacking and setting up your unit.
Do not discard any packaging materials until installation has been
completed.
Extremely high voltage present! Use extreme caution!
Please call your dealer, or Amergraph Corporation at 1-973-383-8700, with any questions or
problems that you may have concerning installation, setup, or operation.
Your new machine is designed to give you many years of reliable, trouble free service with
“built to last” quality, for which Amergraph is known.
Before installing and operating your machine, carefully read the installation and operating
procedures so that you are thoroughly familiar with its operation. Certain procedures under
the troubleshooting section of this manual should be performed only by competent service
technicians experienced in handling high voltage, high power electrical circuits.
Every effort has been made to make the installation as simple as possible so that you can
place your new unit into operation easily. Your Amergraph dealer is a specialist in
Amergraph products and will provide you with assistance in installation and operation.
A product number appears on the Serial Number Label, which is attached to the right side
of the panel near the lamp reflector of your unit (facing the front of the unit). Kindly refer
to this serial number when contacting your dealer or ordering parts.
To Next Page
Loading...