INSTALLATION
CAUTION – EXTREMELY HIGH VOLTAGE!
All AMERGRAPH AdVantage
®
SCREEN EXPOSURE SYSTEMS should be
installed by competent service technicians experienced in servicing and operating
high voltage, high power electrical circuits. Amergraph Corporation assumes no
liability for injury resulting from operation or servicing of this equipment.
Your AMERGRAPH AdVantage
®
SCREEN EXPOSURE SYSTEM is completely
assembled except for the following:
1. Lamp
2. Leveling Feet
3. AdVantage
370 Step
The AdVantage
370 comes equipped with a step for convenient access to
the blanket frame. It is shipped on top of the unit in separate packaging.
SELECTING THE LOCATION
Your AMERGRAPH AdVantage
®
SCREEN EXPOSURE SYSTEM is a compact design,
which requires a relatively minimum amount of floor space. Refer to the list below for the
width and depth of your particular unit.
MODELS 335 & 340: 37” wide x 38” deep
MODELS 350 & 355: 54” wide x 48” deep
MODEL 370: 60” wide x 56” deep
All models require 6 inches (15cm) minimum clearance at the rear and sides to allow for
blower exhaust.
The location you select is important and should be coordinated with the workflow through
your screen-making department. Proper placement of the unit will assure you maximum
production efficiency.
To Next Page
Loading...