ELECTRICAL REQUIREMENTS
The AMERGRAPH AdVantage
®
335, 340, 350, 355, & 370 SCREEN EXPOSURE
SYSTEMS are rated at 240 volts, 60 Hz, single phase power and require a dedicated
electrical service line of at least 20 amps (50 HZ units are available by special order).
Failure to have sufficient power will result in damage to the power supply and WILL VOID
THE WARRANTY OF THE UNIT. The unit must be connected to an approved electrical
ground to protect the user from electrical shock hazard. See your local electrician for advice
and service.
A wall disconnect switch for all models is recommended. All models should be wired by a
licensed electrician in order to conform to all existing local electrical codes.
Wiring for MODELS 335 & 340 should be directly to the wires accessible via the access
hole located at the right rear of the unit.
Wiring for MODELS 350, 355, & 370 should be directly into the electrical box located at
the right rear of the unit.
INSTANT START ULTRA VIOLET LAMP
Your AMERGRAPH AdVantage
®
SCREEN EXPOSURE SYSTEM is equipped with an
instant start U.V. lamp that only operates during an exposure. Therefore, considerable
savings in power costs result in comparison to other types of screen exposure units using
lamps which operate continuously with the aid of a shutter. In addition, via the patented
Megalume
lighting system, Amergraph’s exclusive “true instant start” technology allows
the lamp to restart at all times – even while the lamp remains hot. This hot restrike feature
eliminates the cool down time required to restart the lamp for the next exposure. Since you
can reload and expose screens in rapid succession, Amergraph’s Megalume
instant start
technology largely increases your production.
To Next Page
Loading...