|1
GL300 START GUIDE
Before using our products or installing a device, carefully read our legal
terms which you can find at http://us.americaloc.com/legal_info.html .
To activate your account and device:
1. Go to www.americaloc.com, select United States and click the Activate Now button.
2. Fill in the required information. The IMEI code can be found below the bar code that is printed on
the back of your device. Your account will now be ready to use.
3. Go to www.americaloc.com and log in with the username and password established in the
previous step.
4. Purchase one of our service plans by clicking on the Click to pay service button. A window will
open to provide you with payment instructions.
5. Your device should be active within 15 minutes of payment. This is the time the SIM card takes to
activate. If it takes longer and you do not want to wait, please turn your device OFF and then
ON after initial service payment. Your device already comes with a SIM card installed. Please
do not remove the SIM card.
Appearance:
LED behavior:
Fast flash: Charging
Slow flash: Low battery
Dark: Normal behavior or Device OFF
Solid: Charging completed
Fast flash: Searching for network
Slow flash: Registered on network
Dark: Device OFF
Solid: GPS position calculated
Fast flash: Calculating GPS position
Slow flash: Wrong GPS data (no GPS
signal)
Dark: Off or device is in not moving
The POWER key is in the upper side of the device.
POWER ON: Press the power key for 5 seconds.
Check LEDs are ON before using.
POWER OFF: Press the power key for 5 seconds,
release the button and wait until the
LEDs power off. It may take up to a minute for the
device to power down.
CHARGING: Fully charge your device before using
it for the first time. A full charge takes about 2
hours.
To Next Page
Need help?
General
