Need help?Do you have a question about the American Audio V4000 plus and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| THD | <0.1% |
| Input Sensitivity | 0.775V |
| Input Impedance | 20k ohms |
| Signal to Noise Ratio | >100dB |
| Channels | 2 |
| Input Connectors | XLR, 1/4" TRS |
| Output Connectors | Binding posts, Speakon |
| Protection | Short circuit, thermal, DC offset |
| Cooling | Fan Cooled |
Essential safety guidelines to prevent electrical shock and damage to the unit.
Instructions for checking the amplifier after shipping and basic setup procedures.
Recommendations for mounting the amplifier securely in a standard 19" rack.
Contact details and hours for customer assistance and inquiries.
Rotary knobs for output gain and switches for activating the limiter.
LEDs for signal level, clipping, protection, overheat, and operating mode.
Details on the amplifier's cooling system and the external fuse compartment.
Input jacks, THRU jacks, mode switch, and subwoofer frequency controls.
Speakon connectors and binding posts for connecting speakers to the amplifier.
The ground lift switch and the AC power cord connection point.
Using XLR, 1/4" jacks, and THRU jacks for signal input and routing.
Connecting speakers via binding posts/banana plugs, including important notices.
Instructions for connecting speakers using bare wire or spade connectors.
Guidance for banana plug and Neutrik Speakon connections.
Specific wiring for mono bridge operation using output terminals.
Stereo, Mono Bridge, and Parallel Mono operating configurations.
Stereo and Mono Subwoofer modes for low-frequency output.
High-power mono operation for subwoofers with impedance considerations.
Using Mono Subwoofer and Bi-Amp configurations for specific speaker setups.
Details on the built-in limiter and safe power levels for various loads.
Information on Short Circuit Protection and its indicators.
Information on thermal protection, input/output impedance, and RF decoupling.
Guidance on correct AC voltage and adjusting gain controls for optimal sound.
Explanation of the various LEDs on the front panel and their functions.
Green LEDs indicating the amplifier's current operating mode (Stereo, Mono, Bridge).
Explanation of the red overheat LEDs for each channel.
Step-by-step instructions for assembling Neutrik Speakon connectors to speaker wire.
Diagram illustrating speaker connection for bridge subwoofer mode.
Diagram illustrating speaker connection for stereo subwoofer mode.
Diagram showing typical stereo speaker connections using Speakon or Banana Jacks.
Diagram illustrating typical mono bridge speaker connections.
To Next Page
