Need help?Do you have a question about the American Audio XLT Series and is the answer not in the manual?
Instructions for checking the amplifier's condition and accessories after shipping.
Guidance on mounting the amplifier into a standard 19" rack or rear mounting.
Information on how to contact American Audio for setup help and questions.
Explains the function of the Protect, Clip, and Signal LEDs on the front panel.
Describes the rotary knobs used to adjust the output signal for each channel.
Details the Power switch, Bridge, and Parallel mode indicator lights.
Details Speakon/binding post outputs and XLR/RCA/TRS inputs.
Explains the Low Pass Filter, Sensitivity, and Mode switches.
Information on the fuse holder, AC power cord, and air vents.
Details Speakon/binding post outputs and XLR/RCA/TRS inputs.
Explains the Low Pass Filter, Sensitivity, and Mode switches.
Information on the fuse holder, AC power cord, and air vents.
Guide to connecting audio sources using XLR or 1/4" jacks.
Instructions for connecting speakers using binding posts.
Importance of correct polarity for speaker connections to avoid phase issues.
How to connect speakers using bare wire and in mono bridge mode.
Using Neutrik Speakon connectors for secure speaker connections.
Stripping cable, conductors, and inserting fittings for Speakon connectors.
Matching positive/negative leads and assembling the connector housing.
How to set up and operate the amplifier in stereo mode.
Instructions for mono bridge setup, including cautions.
Guidance for running the amplifier in parallel mono mode for bass speakers.
Explains amplifier protection against overheating and VHF signals.
Details the function of the clip limiter to prevent distortion and damage.
Describes protection against short circuits and incorrect AC power voltage.
Performance details for 8-Ohm and 4-Ohm speaker loads.
How to daisy-chain amplifiers using the LINK function.
Explains gain control calibration and the meaning of front panel LEDs.
Illustrates stereo speaker connections using Speakon and mono bridge using binding posts.
Illustrates parallel mono speaker connections.
Procedures for obtaining warranty service and return authorization.
Conditions that void the warranty, such as alteration or unauthorized repair.
Details RMS output power per channel and total harmonic distortion.
Information on frequency response and slew rate capabilities.
Physical dimensions and weight of the amplifier models.
Details RMS output power per channel and total harmonic distortion.
Information on frequency response and slew rate capabilities.
Physical dimensions and weight of the amplifier models.
General| Total Harmonic Distortion (THD) | <0.1% |
|---|---|
| Channels | 2 |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | 100dB |
| Input Impedance | 20k Ohms (balanced), 10k Ohms (unbalanced) |
| Protection | Thermal, short circuit, DC |
| Connectors (Input) | XLR and 1/4" TRS |
| Connectors (Output) | Binding posts and Speakon |
To Next Page