EasyManua.ls Logo

American DJ Revo III - User Manual

American DJ Revo III
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
American DJ®
6122 S. Eastern Ave.
Los Angeles CA. 90040
www.americandj.com
Rev. 5/09
User Instructions
American DJ® - www.americandj.com - Revo III™ Instruction Manual Page 2
Revo III™ General Information
Unpacking: Thank you for purchasing the Revo IIIby American DJ®.
Every Revo IIIhas been thoroughly tested and has been shipped in
perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears
to be damaged, carefully inspect your xture for any damage and be
sure all equipment necessary to operate the unit has arrived intact. In
the event damage has been found or parts are missing, please contact
our toll free customer support number for further instructions. Please
do not return this unit to your dealer without contacting customer sup-
port rst.
Introduction: The Revo IIIis a four or ten channel, DMX intelligent
LED fixture. The fixture can operate in three different operating modes;
stand alone, sound-active, or in a Master/Slave configuration. The
Revo III™ comes with several built in programs. When used as a stand
alone unit or when used in multiples linked in a master/slave configura-
tion. For best results use fog or special effects smoke to enhance the
beams projections.
Customer Support: American DJ® provides a toll free customer
support line, to provide help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 9:00 a.m. to
5:00 p.m. Pacic Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2941
E-mail: support@americandj.com
To purchase parts online visit http://parts.americandj.com
Warning! To prevent or reduce the risk of electrical shock or re, do
not expose this unit to rain or moisture.
Warning! This may cause severe eye damage. Avoid looking directly
into the light source at all times!
WARNING! Due to the magnifying type lens, please keep
the lens out of contact with direct sunlight. Direct sunlight
can cause heat to build up inside of the unit, which will
seriously damage unit.

Questions and Answers

  • M
    Mark PenaJul 30, 2025
    What to do if my American DJ Revo III has no light output?
    • D
      Daniel DavisJul 30, 2025
      First, ensure your American DJ Lighting Equipment is connected to a standard 120v wall outlet. Next, check the external fuse located on the bottom panel of the unit to see if it has blown. Also, remove the lamp holder and make sure the lamp is properly seated in its socket. Lamps can sometimes become loose during shipping, so ensure the lamp is pushed all the way into its socket. Finally, ensure the fuse holder is completely and correctly seated.
  • J
    joshuaperezAug 13, 2025
    Why American DJ Revo III does not respond to sound?
    • B
      Benjamin SnyderAug 13, 2025
      Your American DJ Lighting Equipment is designed to respond to low frequencies (bass). Tapping on the microphone or using quiet or high-pitched sounds may not activate the unit.

Summary

Revo III General Information and Warnings

Critical Safety Alerts

Essential warnings regarding sunlight, electrical shock, fire, and eye damage.

Revo III Features, Warranty, and Safety

Comprehensive Safety Precautions

Lists essential safety guidelines to prevent shock, fire, and eye damage.

Revo III Setup Procedures

DMX-512 Protocol and Linking

Explanation of DMX protocol for communication and linking fixtures.

Revo III System Menu Configuration

DMX Address Setting

Procedure to set the DMX address using the unit's control buttons.

DMX Channel Mode Selection

How to switch between 4 Channel and 10 Channel DMX modes.

Master;Slave Configuration

Setting the unit to operate as a Master or Slave in a configuration.

Revo III Operating Modes and Controls

Master-Slave Operation

Linking up to 16 units for synchronized light shows via sound activation.

Revo III Cleaning and Troubleshooting

Troubleshooting: No Light Output

Solutions for issues where the unit does not produce any light.

Revo III Warranty and Specifications

Manufacturers Limited Warranty

Details American DJ's warranty policy, terms, and conditions for products.

Product Specifications

Technical details including voltage, lamp, power consumption, dimensions, and weight.

American DJ Revo III Specifications

Power IconPower
voltage120v/60Hz or 230v/50Hz
power consumption50W
fuse7A (120v & 230v)
Lighting Specifications IconLighting Specifications
lamp392 LEDs (140 Red, 105 Green, 84 Blue, and 63 White)
colorsRGB + White
dmx channels4 or 10 DMX Channels
Weight and Dimensions IconWeight and Dimensions
dimensions12.3”(L) x 12”(W) x 13.14”(H) / 312mm x 306mm x 334mm
weight9.5 Lbs. / 4.4 kgs

Related product manuals