American DJ TripleFlex - Page 6

American DJ® - www.americandj.com - TripleFlex Instruction Manual Page 11
American DJ® - www.americandj.com - TripleFlex Instruction Manual Page 12
all times, or “OFF” to switch to have the LED display switch off
after 10 seconds.
3. Press ENTER to conrm.
DISP - This will “ip” the LED display 180º.
1. Tap the MENU button until “dISP” is displayed, press ENTER.
2. Either “dISP” or “dSIP” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. Press the ENTER, and then press and hold the MENU button
for at least 3 seconds to conrm.
MANU - This function automatically adjusts the mirrors to
project an even beam that is used to help you adjust the
xtures so that they are all at the same level. This function
is mainly used when there are more then one xtures.
1. Tap the MENU button until “MANU” is displayed, press
ENTER. “TILT” will now be displayed. The mirrors will stop and
adjust themselves to project an even beam. This beam when
projected from each unit, will allow you to dermine if the units
are level with each other.
2. After you have made your desired adjustments, press the
MENU button to exit.
TEST - This function will run a self test program.
1. Tap the MENU button until “TEST” is displayed, press ENTER.
2. The xture will now run a built-in test program.
FHRS - With this function you can display the running time
of the xture.
TripleFlex System Menu
1. Tap the MENU button until “FHRS” is displayed, press
ENTER.
2. The running time of the xture will now be displayed. Press
MENU to exit.
VER - With this function you can display the version soft-
ware of the xture.
1. Tap the MENU button until “VER” is displayed, press ENTER.
2. The software version will now be displayed. Press MENU to
exit
RSET - Use this function to reset the unit.
1. Tap the MENU button until “RSET” is displayed, press ENTER.
2. The xture will now reset
TripleFlex System Menu