Getting Started 2-5
To set or change a password, do the following:
1. Press the
Pswd
button.
The following message appears on the LCD:
Enter Old PSWD
2. Use the number buttons to enter the permanent or the current user
defined password, then press
Pswd
.
The following message appears on the LCD:
Enter New PSWD
3. Use the number buttons to enter the new password. Press
Pswd
when
finished.
The following message appears on LCD:
ReEnter PSWD
4. Enter the new password again. Press
Pswd
when finished.
If the password successfully changed, you will see the following
message:
Successful PSWD
If the password was not changed successfully, the T
OUCH
T
RACKER
will
beep, and the LCD refreshes and displays the status fields. If this
happens, return to step 1 and repeat the process.
5. Press
LCD Clear
to refresh the LCD.
To Next Page
Loading...
