Chapter 4: Utilities and Advanced User Tasks 4-5
The following message appears on the display:
Push Tracker Ball Up
5. Push the Tracker Ball away from you.
The following message appears on the display:
Release Tracker Ball
6. Release the Tracker Ball.
Tracker Ball calibration is complete.
Displaying Calibration Values
To display the Tracker Ball calibration values, do the following:
1. Use the number buttons to type
34
, then press
Calibrate
.
Information similar to the following will appear on the LCD:
LD2 R00 UD6 D9D
10 10 10 10
2. Press
LCD Clear
to refresh the LCD.
To Next Page
Loading...
