American Dynamics ADTTE - Calibrating the Tracker Ball

4-4 Operator's Manual
Calibrating the Tracker Ball
Calibration “tunes” the Tracker Ball sensors for maximum range of motion
and balance. This function is performed at the factory prior to shipping.
However, if you need to calibrate the Tracker Ball, the following procedure
describes how to do this.
To calibrate the Tracker Ball, do the following:
1. Press the
Calibrate
button.
The following message appears on the display:
Push Tracker Ball Left
2. Push the Tracker Ball to the left.
The following message appears on the display:
Push Tracker Ball Right
3. Push the Tracker Ball to the right.
The following message appears on the display.
Push Tracker Ball Down
4. Push the Tracker Ball towards you.