Adjusting the bicycle for riding comfort
1. Adjusting the seat height
Pull the seat clamp lever outward to loosen the seat post. Adjust the seat the
desired height. The maximum height should not extend beyond minimum
extension mark marked on the seat post. Tighten the seat clamp and close the
lever to lock in the seat’s height.
2. Adjusting the seat tilt and distance
Using a 5 mm Hex wrench, loosen the bolts under the seat. Adjust the seat tilt
and seat distance forward or backward. Tighten the bolts securely to lock in your
desired position.
3. Adjusting the handlebar tilt angle
Use a 6mm Hex wrench to loosen the two screws near the center of the
handlebars. Tilt the handlebars to the desired position. Re-tighten the screws
securely to lock in the handlebars. Be sure all screws are tightened equally.
To Next Page
Loading...