American Panel Walk-in Monitoring System 200 - Technician Menu Options; Unit of Temperature Selection

PROGRAMMING
14
5. Technician Menu (Celsius/Fahrenheit Unit Selection, Temperature Probe Offset,
PC Connection Settings, HACCP Data Recording Settings)
Note: The technician menu includes settings that if changed could interfere with the functionality of the
controller. Enter the technician menu only if it is absolutely necessary.
Before entering the technician menu, the controller has to be in the “OFF” state.
If it is not, press and hold for 5 seconds.
The display will show:
Press and hold for 10 seconds.
The display will show:
Enter The Access Code
To enter the default access code, press the following buttons in order: .
When finished, press .
The display will show:
Select The Displayed Unit Of Temperature (Celsius/Fahrenheit)
To change the displayed unit of temperature (the flashing value) from Fahrenheit
to Celsius, press or .
When finished, press
.
The display will show:
This setting is for factory technician only. Press
to skip.
The display will show:
This setting is for factory technician only. Press
to skip.