American Panel Walk-in Monitoring System 200 - Operating WIMS 200; Turn On Controller; Display Air Temperature and Time; Display Date and Time

OPERATING
18
7. Operating WIMS 200
7.1. Turn On The Controller
From the “OFF” state, turn the controller on by pressing .
The controller needs to stay on in order to operate. Leave it on at all times.
7.2. Read The Walk-in Air Temperature And The Current Time
When on, WIMS 200 will alternate the inside air temperature display with the
time display.
(For 10 seconds)
Alternating with:
(For 5 seconds)
7.3. Display The Current Date And Time
To display the current date and time, make sure the controller is on and then press
and hold . While holding the display will indicate the readings
illustrated in the figures on the right.
Alternating with:
Alternating with:
7.4. Display The Door Frame Heater Temperature
WIMS 200 monitors and controls the door frame heater temperature at all times.
To display the door frame heater temperature, make sure the controller is on and
then press and hold
for couple of seconds. The display will indicate the
door frame heater temperature. As an example see the illustration on the right.
When is released, the controller will switch back to air temperature display.