PROGRAMMING
16
The controller will switch to the baud rate setting and the display will show the
message on the right for a few seconds.
The display will show:
38400 is a common baud rate for the most computers. Press
to leave this
setting unchanged.
The display will show:
This setting is for factory technician only. Press to skip.
The display will show:
This setting is for factory technician only. Press to skip.
The display will show:
This setting is for factory technician only. Press to skip.
The display will show:
This setting is for factory technician only. Press to skip.
The display will show:
HACCP Data Recording Settings
The flashing value represents the recording time interval in minutes for the
HACCP data. By default the recording time interval is set to 15 minute. This
means that every 15 minutes the WIMS 200 will write the HACCP data in its
own memory.
Press or to increase or decrease the recording time interval.
When finished, press .
The display will show:
To Next Page
Loading...