Need help?Do you have a question about the American Standard allegiance 16 and is the answer not in the manual?
General| Model | Allegiance 16 |
|---|---|
| Type | Heat Pump |
| Compressor Type | Single-Stage |
| Refrigerant | R-410A |
| Warranty | 10-year limited warranty on compressor and outdoor coil |
| Sound Level | 72 dB |
| Stages | 1 |
| Cooling Capacity (BTU/h) | 24, 000 - 60, 000 |
| Heating Capacity (BTU/h) | 24, 000 - 60, 000 |
| Sound Level (dB) | 72 |
Details accessories like EDC and hard start kits needed for operation at low outdoor temperatures.
Information on Evaporator Defrost Control kits and compressor crankcase/hard start kits.
Describes appropriate methods for mounting and securing Allegiance/Heritage 16 units.
Outlines primary factors for minimum clearances: airflow, service access, codes, and design temperature.
Specifies minimum clearances for units installed in corners, considering ambient temperature.
Details minimum clearances for units in fenced corners, including fence openings.
Specifies clearances for multiple units in fenced corners, including fence opening requirements.
Provides minimum clearance requirements for units installed next to one wall.
Outlines minimum clearances for installing multiple units on pads or rooftops.
Specifies requirements for fence height, air passages, and placement for unit clearances.
Presents unit airflow data and calculation methods for required fence openings.
Details requirements for windshields to block prevailing winds at low outdoor temperatures.
Explains National Electric Code (NEC) Article 110.26 for minimum working clearances and safety.
Explains the function of liquid and gas refrigerant lines and their general limitations.
Details maximum allowable linear and vertical lengths for gas and liquid refrigerant lines.
To Next Page