American Standard Cadet 3 2829 User Manual (English)

Questions and Answers:

K
Kenneth OlsonJul 30, 2025
What to do if my American Standard Plumbing Product does not flush?
- R
  Renee OrtegaJul 30, 2025
  If your American Standard Plumbing Product doesn't flush, it might be due to a few reasons. First, check if the water supply valve is closed and open it to allow the tank to fill. Another cause may be a blocked supply line, so shut off the water supply, disconnect the line, and inspect the gaskets and washers before reassembling. Also, the flush valve chain might be too loose or disconnected; readjust its length. Finally, sand or debris could be lodged in the water control; in this case, shut off the water supply and clean the components.
M
Melinda CuevasAug 6, 2025
Why my American Standard Cadet 3 2829 toilet does not shut off?
- M
  Martin ReynoldsAug 6, 2025
  If your American Standard Plumbing Product toilet does not shut off, it could be due to a few reasons. The flush valve chain might be too tight, holding the flush valve open, so readjust the chain length. Alternatively, the flush valve seat and/or flapper may be worn or deformed, requiring you to shut off the water supply and replace the flush valve. Lastly, sand or debris could be lodged in the water control; in this case, shut off the water supply and clean the components.
L
Linda WilliamsAug 14, 2025
How to fix poor or sluggish flush in American Standard Cadet 3 2829?
- E
  Edwin RobertsAug 14, 2025
  A poor or sluggish flush in your American Standard Plumbing Product could be due to several factors. Check that the refill tube is correctly connected to the water control and inserted into the tank overflow without any kinks or damage. Ensure the supply valve is fully open and that the correct supply tube size is used. A partially clogged trapway, drain pipe, or vent can also cause this issue; remove any obstructions, and consult a plumber if necessary. Finally, low supply pressure could be the culprit; normal supply pressure must be at least 20 psi.
G
Gerald HamiltonAug 21, 2025
How to stop American Standard Plumbing Product fill valve from leaking after shutting off?
- S
  Sandra WallerAug 21, 2025
  If your American Standard Plumbing Product fill valve shuts off but continues to leak, it could be because the end of the refill tube is inserted into the overflow pipe below the water level in the tank; attach the refill tube to the overflow pipe using the 'S' clip provided. Alternatively, the flush valve may be leaking because it's worn, dirty, or misaligned with the tank ball or flapper; replace it with a new flapper.

American Standard Cadet 3 2829 Specifications

General

Product Type	Toilet
Model Number	2829
Brand	American Standard
Collection	Cadet 3
Bowl Shape	Elongated
Rough-In Size	12 inches
Seat Included	No
Material	Vitreous China
ADA Compliant	Yes
Color	White
Flush Type	Gravity
Flush Valve Size	3 inch
Water Consumption	1.28 GPF

Summary

Toilet Installation Guide

Remove Old Toilet

Instructions for removing the existing toilet, including shutting off water and disconnecting supply lines.

Roughing-In Dimensions

Specifies the required distance from the finished wall to the closet flange centerline for various models.

Install Closet Bolts

Guide for installing closet bolts into the flange channel, ensuring they are parallel and properly spaced.

Install Wax Seal

Instructions for applying a wax ring evenly around the toilet's waste flange horn and adding sealant.

Position Toilet on Flange

Steps for placing the toilet onto the flange, aligning bolts with mounting holes, and loosely securing nuts.

Completing Toilet Installation

Install Toilet Bowl

How to position and press the toilet bowl onto the wax ring and flange, then tighten nuts evenly.

Install Toilet Tank

Procedure for installing the tank onto the bowl using the rubber gasket and tightening mounting bolts.

Install Toilet Seat

Guidance to install the toilet seat according to the manufacturer's specific directions.

Connect Water Supply

Instructions for connecting the water supply using appropriate parts for different tubing types.

Operation and Maintenance

Fill Valve Adjustment

Details on adjusting the water level in the tank using the float cup and adjustment rod.

Care and Cleaning

Recommendations for cleaning the toilet with mild soap and water, avoiding harsh chemicals.

Repair Parts List

A list of available repair parts for the toilet, cross-referenced by part number and model compatibility.

Troubleshooting and Warranty

Troubleshooting Guide

Identifies common toilet problems, their possible causes, and corrective actions for resolution.

Five Year Limited Warranty

Details the limited warranty terms, coverage, exclusions, and claim process for the toilet product.

Related product manuals

American Standard Cadet 3 2383

4 pages

American Standard Cadet 8115

2 pages

American Standard Cadet 6425

2 pages

American Standard Cadet 8125

1 page

American Standard CADET 8115F

8 pages

American Standard Cadet 2386.012

2 pages

American Standard Cadet 2998.012

1 page

Cadet Three-Handle Bath/Shower 3375

4 pages

Cadet Single Control Kitchen Faucet 8410

2 pages

Colony Soft 3-Handle Bath/Shower Fitting 3375.302

2 pages

Reliant 3 7385 Series

18 pages

American Standard Champion-4

8 pages