4
6
12
5
SLOT
MOUNTING
SURFACE
Turn off hot and cold water
supplies before beginning.
CAUTION
Insert SPOUT (1) and CABLE CONNECTOR (12) through center hole, making sure
the SPOUT ESCUTCHEON (2) and SEAL WASHER (3) are properly seated.
Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT
SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the mounting
hole and the slot in the BRASS WASHER (5) faces toward the rear of the sink.
Tighten LOCKNUT (6) firmly. Fig. A.
Hand tighten LOCKNUT (11) to secure VALVE BODY (8). Repeat above
steps for opposite VALVE BODY (8A).
Install LOCKNUT (11) onto VALVE BODY (8). From under side of mounting
surface, install VALVE BODY (8) through valve mounting holes. Threads of
VALVE BODY (8) should extent at least 5/16 of a inch above mounting
surface top. Fig. B. Thread ADAPTER (10) onto VALVE BODY (8) until snug
against internal stop. If necessary, adjust LOCKNUT (11).
1
1A
M968672 Rev. 1.1
4508
4508S
Certified to comply with ANSI A112.18.1
Installation
Instructions
SYMPHONY
Spread Lavatory Faucet
with Speed Connect™ Drain
INSTALL SPOUT
INSTALL VALVE BODY
1
2
1
10
9
8
8a
10
9
11
3
Place RUBBER RING (9) into ADAPTER (10).
8
5/16'' MIN.
7
Adjustable Wrench Screwdriver Channel Locks
Recommended tools
Tubing Cutter
Fig. A.
Fig. B.
1
Congratulations on purchasing your American Standard
faucet with Speed Connect drain, a feature found only
on American Standard faucets.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
Heplful tips for removing your current drain can be found in the Troubleshooting section of these instructions.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Speed Connect Drain*
• 1/3 of the parts, installs in 1/3 of the time
• No tools needed
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
11
To Next Page
Need help?
General
