American Standard Studio-S 4803100 User Manual

- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2019
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
1
M985010 (3/19)
• Make certain the SEAL (1) is properly seated in recess of
spout base.
• Insert all HOSES (2) and SHANK (3) through MOUNTING
RING (4) and mounting surface. Do not use putty.
• Insert HOSES (2) through RUBBER WASHER (5), BRASS
WASHER (6), and threaded LOCKNUT (7).
• Assemble RUBBER WASHER (5), BRASS WASHER (6), and
threaded LOCKNUT (7) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7).
• Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
INSTALL FAUCET
Studio-S
®
Pull-Out Kitchen Faucet
INSTALLATION
INSTRUCTIONS
4803100
Flat Blade Screwdriver Adjustable Wrench Plumbers’ Putty or CaulkingPhilips Screwdriver
Certied to comply with ANSI A112.18.1M
1
4
3
2
5
6
8
7
2
CAUTION
Turn off water at
main supply

American Standard Studio-S 4803100 Specifications

General

Brand	American Standard
Model	Studio-S 4803100
Category	Plumbing Product
Language	English

Summary

Install Faucet

Seat Faucet Seal

Ensure the seal is correctly positioned in the spout base recess before installation.

Insert Faucet Components

Pass hoses and shank through the mounting ring and surface without using putty.

Assemble Faucet Base

Connect hoses, washers, and locknut to the shank from the underside and hand-tighten.

Tighten Locknut

Secure the locknut using screws, tightening evenly for consistent pressure.

Make Water Supply Connections

Connect Flexible Supplies

Connect hot and cold water supplies to the fittings, tightening with an adjustable wrench.

Manage Supply Hose Length

Loop hoses if too long to prevent kinking; purchase additional length if needed.

Connect Spray Hose and Install Weights

Attach Spray Hose Weight

Install the weight onto the spray hose approximately two feet from the sink deck.

Connect Spray Hose

Connect the spray hose to the coupling nut, ensuring the seal washer is in place.

Test Installed Faucet

Flush Water Lines

Operate the faucet handle through hot and cold positions to flush lines.

Check Spray Operation

Test the toggle button to switch between stream and spray modes.

Service Faucet

Address Dripping Faucet

Operate handle multiple times; clean flow control device if dirt accumulates.

Clean Cartridge and Manifold

Disassemble to clean cartridge, manifold, and seals for reduced flow issues.

Care Instructions

Cleaning Recommendations

Rinse with clear water and dry with a soft cotton cloth; avoid harsh cleaners.