Need help?Do you have a question about the AMERITRON ALS-606S and is the answer not in the manual?
General| Input Impedance | 50 Ohms |
|---|---|
| Output Impedance | 50 Ohms |
| Type | Solid State |
| Power Output | 600 Watts PEP |
| Frequency Range | 1.8 to 30 MHz |
| Power Supply | 120/240 VAC |
| Cooling | Fan-cooled |
General guidance on placing the amplifier and power supply and making connections.
Details on connecting the amplifier to the power mains and available power supplies.
Specifics on operating the ALS-600SPS switching power supply, including voltage ranges.
Instructions for connecting RF cables, ALC, and keying lines.
Notes on specialized connectors for automatic band selection.
Prerequisites for safe operation and setting the band switch.
Explanation of warning lights, fault codes, and the fault alarm table.
Details on power supplies and their electrical requirements for the ALS-606.
Required space, precautions, and detailed wiring instructions.
Specification of operational frequency bands and guidelines for MARS/CAP use.
Functions of the multimeter, band select knob, and ALC set control.
Operation of power, standby, and alarm indicator lights.
Details on connecting the power supply and optional ALC.
Functions of RF input/output, relay, ground, and radio interface ports.
Use of RJ45 remote connectors and key loop jack.
Verifying connections, powering on, and setting basic controls.
Performing low-power tests and adjusting ALC for optimal performance.
Table and instructions for setting line voltage on the ALS-600PS.
Instructions for ALS-600SPS voltage and an overview of ALS-606 functionality.
How the amplifier operates across different bands and drive levels.
Descriptions of the 1KWF6 filter, BSW3 bandswitch, and CB2 control boards.
Descriptions of MB2, PAM-606, PD8m, and RJ45 boards.
Functions of the relay and SWR directional coupler boards.
Schematic diagram for the 1KWF6 low-pass filter board.
To Next Page