Page 8 <&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 64017
?@<6AQ RS6;@ACRE D@CEA6E@ET6?6AFS
R/*(,$"83%C8#$('4$"&8#
%;*,9%$.*%6EAC;6%CDSR;A@EA%?@<6AQ%CE<R;D@ACRE%#*4$"&8%
,$%$.*%+*3"88"83%&2%$."#%5,8',7%"847'9"83%,77%$*Z$%'89*(%
#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
67*4$("4,7%#.&4[%4,8%4,'#*%9*,$.%&(%"8='(>`%E6!6;%ARFTB%
*Z/&#*9%4&89'4$&(#%&2%*7*4$("4"$>1
V*8*(,7%R/*(,$"83%C8#$('4$"&8#
;6G0CE;F?B
1� Press the ;6G0CE;F?B button
once to enter relative measurement
mode and store a reference value�
2� Take additional measurements to
display difference between measured
value and reference value�
3� Hold ;6G0CE;F?B button for two or
more seconds to enter inrush mode�
E&$*- Relative measurement mode can
only be used in manual range mode�
D,8',7%;,83*
The Meter’s default range is @FAR� To select manual range, press ;@E� Each press
of the button increases the range� Hold the ;@E button to return to auto-range�
E&$*- Manual range cannot be used while measuring frequency�
<(*H'*84>%,89%X'$>%T>47*%D*,#'(*5*8$#
1� While working with voltage or
current ranges, press the B_^
button one time to measure the
frequency of the voltage or current�
2� Press the B_^ button twice to
measure the duty cycle of the voltage
or current� The range is set to manual�
3� Press the B_^ button a third
time to return to normal voltage
or current measurement�
E&$*- Frequency and duty cycle
modes cannot be used while in
minimum or maximum value mode�
D"8"5'5%,89%D,Z"5'5%!,7'*%D*,#'(*5*8$#
1� Press the DCE0D@] button one
time to measure the maximum
value at any range�
2� Press the DCE0D@] button
two times to measure the
minimum value at any range�
3� Press the DCE0D@] button three times
to display difference between maximum
and minimum measurements�
4� Hold the DCE0D@] button
for one or more seconds to
return to normal mode�
E&$*- The Meter is automatically set to
manual range mode when measuring
minimum or maximum value�
E&$*- Frequency and duty cycle modes
cannot be used while in minimum
and maximum value mode�