EasyManua.ls Logo

Ametek 387 - 5.7.2 SMC Has No Backlighting 5-36; 5.8 Se lect;Re set Switches not Working 5-36

Ametek 387
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5.7.2 SMC Has No Backlighting
Symptom - SMC backlighting does not light when headlights are switched on.
Probable Cause - No backlighting power to the SMC.
Note - When the headlights are first turned on, the message center’s LCD
backlighting will turn off momentarily and then turn back on. This is nor-
mal and is not a problem.
Procedure: Follow the steps in Figure 5-19.
5.8 Select/Reset Switches not Working
Symptom - The switches do not operate the message center functions.
Probable Cause - Defective switch or switch wiring.
Procedure: Follow the steps in Figure 5-20 on page 5-37.
Troubleshooting Procedures 5-36 072-40245 B
Figure 5-19 SMC Backlighting Problem

Table of Contents

Related product manuals