14 123199 04
3.8 AUTO STEP
The AUTO STEP function (cf. fig. 5) is used to step automatically
between a range of different set-temperatures.
Press . The instrument displays the number of set-
temperature .
Press or to select the required number of steps.
Press to accept your selection. The first set-
temperature will flash.
Press or to select the required temperature.
Press to accept your selection. The next set-
temperature will flash. This process will be repeated until the
last value has been accepted. The extra for which you
wish the calibrator to remain at every step will flash.
Press or to set the required number of minutes.
Press to accept your selection. The function will be
activated.
Press after the last set-temperature to end the function
or to leave the function at any time.
To Next Page
Loading...
Need help?
General
