Ametek SEQUOIA Series - Transient Programming; Voltage Transient Programming

Sequoia / Tahoe Series User Manual California Instruments
230 M447352-01 REV-A
5.12 Control Interface Screen
The CONTROL INTERFACE screen provides the ability to configure the power source for remote control
through the data communications interfaces, and also to set up the functionality of the Remote Inhibit
signal. For detailed information on setting up the data communications digital interfaces using the SCPI
commands or the Sequoia\Tahoe Virtual Panels GUI, refer to the Sequoia Series Programming Manual
P/N M447353-01, refer to AMETEK PPD website, www.programmablepower.com, to download the latest
version.
In the eLoad Mode of operation, the External Analog programming feature is not applicable for the Power
Programming and Parallel RLC Programming modes. Submenu for the Analog programming won’t be
available on the Control Interface screen, refer to Figure 5-239.s
The top-level menu of the CONTROL INTERFACE screen is shown in Figure 5-238 and Figure 5-239. It
could be reached in one of two ways:
1. Tapping CONTROL INTERFACE on the HOME Screen of the front panel touch-screen.
2. Scrolling to CONTROL INTERFACE with the encoder and depressing the encoder switch.
The UP arrow button will return to the previously selected screen menu (in this case the HOME Screen).
The HOME button will return to the HOME screen that has the top-level menu for the sub-menu being
displayed; for the CONTROL INTERFACE screen top-level menu, is the HOME Screen.
Figure 5-238. CONTROL INTERFACE Screen
Figure 5-239. CONTROL INTERFACE Screen for eLoad-Power and Parallel RLC Programming
Mode
The following sub-menus are available in the CONTROL INTERFACE menu:
Entry Description