1-36
S100
Revised 10/2005
e-mail: service@amfreece.cz ; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
D - MACHINE ADJUSTMENT
Give straight edge of the gauge over front edge of the supporting surface of the loopers. Check the space
between the gauge and the table slat.
By turning of the handle on the left side of the machine, go with the table to half of the second row of the
stitches.
Check the distance between gauge and the left table slat again.
The position is correct, if there is no clearance between the gauge and the straight edge - the edge is parallel
to the table slat.
If not, modify the turning of the sewing mechanism by 180
o
± 2
o
so that after machine lifting, loosen the nut
stud of the rod and shift until tilt between the gauge and the table slat is decreased to the half. Tighten the
nut.
During the stud movement towards 3, increase the rotation angle of sewing mechanism , towards 4, the
turning angle decreases.
Normally, this adjustment is pursued several times until you reach correct adjustment.
1/2
1/2
2. row of
stitches
1. row of
stitches
Gauge
Space
Table slot
Space
1. row of stitches
2. row of stitches
To Next Page
