AMI Analyzer Manual •
••
• 23
Handling information
NOTE: Oxygen sensors are sealed and under normal circumstances their contents do not present a health hazard. The following
information is given as a guide in the event of a leak.
Hygienic practices: Wash hands after handling
Protective clothing: Rubber gloves, chemical splash goggles.
Clean up procedures: Wipe down the area several times with a wet paper towel, using
a fresh towel each time.
Protective measures during cell replacement: Before opening the bag containing the sensor, check the sensor
for leakage. If any is found, do not open the bag. If there is
liquid around the sensor installed in the instrument, put on
gloves and eye protection before removing it.
Disposal: Must be in accordance with all applicable federal, state and local
regulations.
Both lead and potassium hydroxide are considered poisonous
substances and are regulated under TSCA and SARA title III.
EPA waste number: D008
California waste number: 181
DOT information: RQ Hazardous Waste Solid N.O.S. (lead), 9, UN3077, PG III
NOTE: The above information is derived from the supplier's MSDS. This information is believed to be correct, but is not necessarily
inclusive and should be used only as a guide. Advanced Micro Instruments shall not be held liable for any damage arising out of using
or abusing this product.
To Previous Page
Loading...