Why my Amica AWI612L does not fill with water?
If your Amica Washer isn't filling with water, make sure the water valve is on, the program is correctly set, and the water pressure is adequate. Also, check that the water supply hose is properly reconnected and not bent or blocked, and ensure the appliance door is closed.
How to solve water outflow problems in Amica AWI612L?
If you're experiencing water outflow problems with your Amica Washer, inspect the pump filter and the outlet lead. Also, verify that the height of the outlet hose is between 0.6m and 1m from the bottom of the washing machine.
What to do if the load in Amica Washer has not been spun?
If the load in your Amica Washer hasn't been spun, try replacing the load evenly in the drum and cleaning the pump filter.
How to stop Amica AWI612L Washer from vibrating?
If your Amica Washer is vibrating, ensure that the transport safety devices have been removed. Level the appliance and secure the legs by tightening the nuts.
Why Amica AWI612L Washer washing is not properly rinsed?
If your washing is not properly rinsed in your Amica Washer, use the correct amount of cleaning agent based on the dirtiness of the washing and the water hardness, following the instructions on the cleaning agent’s packaging. Also, clean the pump filter.
How to eliminate unpleasant smell in Amica AWI612L Washer drum?
If you notice an unpleasant smell in the drum of your Amica Washer, activate the Autoclean cycle without a load. Consult the washing programme table for instructions.
Why is there foam from the detergent drawer of my Amica Washer?
If you see foam coming from the detergent drawer of your Amica Washer, reduce the amount of detergent you are using. Check the water hardness, the amount of detergent used, and the type of detergent used in the drum.
Why Amica Washer has simultaneous intake and draining of water?
If your Amica Washer is simultaneously taking in and draining water, ensure that the end of the outlet hose is higher than the water level in the appliance, ideally at a height of 0.6m to 1m.
What to do if Amica AWI612L operation is interrupted?
If the operation of your Amica Washer is interrupted before the program has finished, check the power supply, water supply, and water outlet.
Why Amica AWI612L has short breaks during the wash cycle?
Short breaks during the wash cycle of your Amica Washer can occur because the water in the appliance is being automatically refilled, or it may be a pause caused by the removal of excess foam.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Product colour | White |
| Capacity | 6 kg |
| Spin Speed | 1200 RPM |
| Built-in display | Yes |
| Door hinge | Left |
| Drum material | Stainless steel |
| Spin-drying class | B |
| Washing class | A |
| Delayed start timer | Yes |
| Width | 595 mm |
| Height | 85 cm |
To Next Page
