44 Amico Beds Corporation
Electromagnetic Compatibility
Table A.4 – Recommended Separation Distances
Recommended separation distances between portable and mobile RF communications equipment and the Apollo Bed
(B-AM1-400X).
The Apollo Bed (B-AM1-400X) is intended for use in the electromagnetic in which radiated RF disturbances are controlled.
The customer or user of the Apollo Bed (B-AM1-400X) can help prevent electromagnetic interference by maintaining
a minimum distance between portable and mobile RF communications equipment (transmitters) and the Apollo Bed
(B-AM1-400X) as recommended below, according to the maximum output power of the communications equipment.
Rated Maximum Output Power
of Transmitter (W)
Separation Distance According to the Frequency of Transmitter (m)
from 150kHz to 80MHz
d= 1.2 x √P
from 80MHz to 800MHz
d= 1.2 x √P
from 800MHz to 2,5GHz
d= 2.3 x √P
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For the transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in Watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
EMI Information (FCC)
This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment is a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
WARNING: Changes or modifications not expressly approved by Amico Beds Corporation could void the user’s
authority to operate the equipment.
To Next Page
Loading...
