www.amico.com 19
Troubleshooting
The following tools may be required:
• 3/8" wrench
• 7/16" combination wrench
• 1/2" combination wrench
• 9/16" combination wrench
• Philips-head screwdriver (Sizes #1 and #2)
• Slot-head screwdriver
• Needle-nose pliers
• Rubber mallet
• Cable ties
• Wire cutter
• Multimeter/voltmeter
• If any cables need to be replaced, consult the “Cable Schematic” and note the corresponding part number.
• To remove damaged cables, use the wire cutters to remove any cable ties holding the cable in place. Note the
location of the cable tie(s) so that the new cable is secured in the same place(s).
To Next Page
Loading...
